2-1. BOARD LAYOUT
MAIN board
SUB board
2-2. REPLACEMENT OF MAIN PARTS
2-2-1. Notes on Replacement of MAIN Board
To replace the MAIN board, perform adjustment referring
to Section 3."ALIGNMENT".
2-2-2. Replacement of CRT/DY Ass'y
Note:
If a deflection yoke is replaced, you should
replace assembly of CRT and deflection yoke
(CRT/DY ASS'Y).
1. Remove four screws as shown in Figure and remove
the bottom case.
Screws(B3 X 8)
2-1 (E)
2-2
SECTION 2
SERVICE INFORMATION
LED(A) board
LED(B) board
Screws(B3 X 8)
Bottom case
2. Remove the slide ring as shown in Figure.
Remove two screws and remove the CRT/DY ASS'Y
from outside holders B and T.
Outside holder T
CRT/DY Ass'y
3. Untie two strings and remove an adhesive tape and
Cable Holder.
String
Cable holder
Outside holder B
Screws(BTP3 X 12)
Slide ring
String
Adhesive tape
DXF-701 (UC)
DXF-701CE (CE)