For Cut Sheet(1 Sheet) - Epson SC-T5400 Series User Manual

SC-T5400 Series/SC-T5400M Series/SC-T3400 Series/SC-T3400N Series User's Guide
❏ Tracing Paper
❏ Tracing Paper <LowDuty>
❏ Matte Film
❏ Blueprint Paper
To select a paper type that is not displayed on the
screen, touch Others.
Select a category and select the target paper type.
Note:
If you scroll downward in the category selection
screen, Custom Paper appears. To select custom
paper that has already been registered, touch
Custom Paper.
D
When a paper type is selected, the screen returns
to the one in step 1.
If you will not set the remaining amount
management setting, touch OK.
E
Touch Paper Remaining.
F
Touch Setup.
The setting changes to On, and Remaining
Amount and Remaining Alert are enabled.
Touch each one and enter a value as follows.
❏ Remaining Amount: Total length of roll paper
(see the manual supplied with the roll paper)
Loading and Setting the Paper
❏ Remaining Alert: Remaining amount value
G

For Cut Sheet(1 sheet)

Configure the following settings after loading cut sheets.
Settings of Paper Type
This is the most important setting to obtain the
optimum print results. Not setting a paper type that
matches the loaded paper will cause wrinkles, scuffing,
uneven colors, and other trouble.
Settings of Paper Size
Paper size will not be automatically detected. Set the size
of the loaded paper.
45
that will be the timing for displaying the
remaining amount warning notification.
Note:
On the keypad screen for entering a numeric value,
enter numbers that include a number of the first
decimal place. For example, if you want to enter 5
m, touch [5] and [0].
Touch at the top left of the screen to return to
the screen of step 5 and then touch OK.
You can start printing once Ready appears on the
screen.