Battery Charge Indicator; Starting Operation - Bosch Professional GLI 18V-300 Original Instructions Manual

6 | English
(5) Utility hook
(6) Handle (insulated gripping surface)
a) Accessories shown or described are not included with the
product as standard. You can find the complete selection of
accessories in our accessories range.
Technical Data
Cordless worklight
Article number
Rated voltage
A)
Lighting duration , approx.
Weight according to
B)
EPTA-Procedure 01:2014
Total luminous flux, max.
Recommended ambient tem-
perature during charging
Permitted ambient temperat-
C)
ure during operation and
during storage
Recommended rechargeable
batteries
(1.5−8 Ah)
Recommended chargers
A) Measured at 20−25 °C with rechargeable battery GBA 18V
4.0Ah.
B) Depends on battery in use
C) Limited performance at temperatures <0 °C
The colour rendition of illuminated objects can be distorted.
Assembly
Battery Charging (Accessory)
Use only the chargers listed in the technical data. Only
u
these chargers are matched to the lithium-ion battery of
your power tool.
Note: The battery is supplied partially charged. To ensure
full battery capacity, fully charge the battery in the charger
before using your tool for the first time.
The lithium-ion battery can be charged at any time without
reducing its service life. Interrupting the charging process
does not damage the battery.
The lithium-ion battery is protected against deep discharge
by the Electronic Cell Protection (ECP). A protective circuit
switches the cordless worklight off when the battery is
drained.
Do not continue to press the On/Off switch after the
u
worklight has been automatically switched off. The
battery can be damaged. Ensure that the battery is
charged and that the worklight has cooled before switch-
ing on the worklight again.
1 609 92A 5X6 | (26.04.2021)
GLI 18V-300
3 601 DA1 1..
V= 14.4/18
min/Ah 300
kg 0.63–1.1
lm 300
°C 0 to +35
°C –20 to +50
GBA 14,4V...
GBA 18V...
ProCORE18V...
GAL 18...
GAX 18...
GAL 36...
To remove the battery (1), press the release button (2) and
pull the battery out of the cordless worklight. Do not use
force to do this.
Follow the instructions on correct disposal.

Battery charge indicator

The green LEDs on the battery charge indicator indicate the
state of charge of the battery. For safety reasons, it is only
possible to check the state of charge when the power tool is
not in operation.
Press the button for the battery charge indicator or
show the state of charge. This is also possible when the bat-
tery is removed.
If no LED lights up after pressing the button for the battery
charge indicator, then the battery is defective and must be
replaced.
Battery model GBA 18V...
LEDs
3× continuous green light
2× continuous green light
1× continuous green light
1× flashing green light
Battery model ProCORE18V...
LEDs
5× continuous green light
4× continuous green light
3× continuous green light
2× continuous green light
1× continuous green light
1× flashing green light
Operation

Starting Operation

Inserting the Battery
Push the charged battery (1) into the battery holder until it
clicks into place.
Switching On and Off
To switch on the cordless worklight, press the on/off
switch (4).
To switch off the cordless worklight, press the on/off
switch (4) again.
to
Capacity
60−100 %
30−60 %
5−30 %
0−5 %
Capacity
80−100 %
60−80 %
40−60 %
20−40 %
5−20 %
0−5 %
Bosch Power Tools