About This Document; General Safety Instructions - Bosch Rexroth SE352 Manual

18/88 Bosch Rexroth AG
1

About this document

This manual contains important information
on the safe and appropriate assembly,
transport, commissioning, operation,
maintenance, disassembly and simple
troubleshooting of the SE352 and SE352M
control units.
Read these instructions completely,
especially chapter "2 General safety
instructions" on page 18, before working
with the SE352/SE352M control unit.
Related documents
The SE352 and SE352M control unit is a
system component.
Also observe the instructions for the other
system components.
Also observe the generally applicable, legal
or otherwise binding regulations of European
or national legislation and the rules for the
prevention of accidents and for
environmental protection applicable in your
country.
2 General safety
instructions
The SE352/SE352M control unit has been
manufactured according to the accepted
rules of current technology. There is,
however, still a danger of personal injury or
damage to equipment if the following general
safety instructions and the warnings before
the steps contained in these instructions are
not complied with.
• Read these instructions completely and
thoroughly before working with the
SE352/SE352M control unit.
• Keep these instructions in a location where
they are accessible to all users at all times.
SE352/SE352M | 3 609 929 B61/2008-09
• Always include the operating instructions
when you pass the SE352/SE352M
control unit on to third parties.
Intended use
The SE352/SE352M control unit is a
component in terms of the machine directive
98/37/EC and is not a ready-for-use
machine. The product is exclusively intended
for being integrated in a machine or system or
for being assembled with other components
to form a machine or system. The product
may be commissioned only if it is integrated
in the machine/system for which it is
designed and the machine/system fully
complies with the EC machine directive.
Observe the operating conditions and
performance limits specified in the technical
data.
The SE352/SE352M control unit is a work
appliance and not designed for private use.
Intended use includes having read and
understood these instructions, especially the
chapter "2 General safety instructions".
The SE352/SE352M control unit is intended
for installation in the BT356 card rack or
SB35x system box.
Improper use
Any use of the SE352/SE352M control unit
other than described in chapter "Intended
use" is considered as improper.
Personnel qualifications
Assembly, commissioning and operation,
disassembly, service (including maintenance
and repair) require basic electrical and
mechanical knowledge, as well as
knowledge of the appropriate technical
terms. In order to ensure operating safety,
these activities may therefore only be carried
out by qualified technical personnel or an
instructed person under the direction and
supervision of qualified personnel.