Section 3: Setup; Unpacking; Needed For Setup; Inventory - Grizzly G0944 Owner's Manual

Unpacking

This machine was carefully packaged for safe
transport. When unpacking, separate all enclosed
items from packaging materials and inspect them
for shipping damage. If items are damaged,
please call us immediately at (570) 546-9663.
IMPORTANT: Save all packaging materials until
you are completely satisfied with the machine and
have resolved any issues between Grizzly or the
shipping agent. You MUST have the original pack-
aging to file a freight claim. It is also extremely
helpful if you need to return your machine later.

Needed for Setup

The following items are needed, but not included,
for the setup/assembly of this machine.
Description
• An Assistant ............................................... 1
• Safety Glasses and Respirator .................. 1
• Mounting Hardware .................... As Needed
• Tape Measure............................................. 1
• Drill and Bits ............................... As Needed
• Marker/Pencil .............................................. 1
• Support Board ............................ As Needed
• Wrench or Socket
• Wrench or Socket 10mm ............................ 1

Inventory

The following is a list of items shipped with your
machine. Before beginning setup, lay these items
out and inventory them.
If any non-proprietary parts are missing (e.g. a
nut or a washer), we will gladly replace them; or
for the sake of expediency, replacements can be
obtained at your local hardware store.
-14-

SECTION 3: SETUP

Qty
⁄ " ................................. 1
3
8
Box 1 (Figure 5)
A. Hardware (Not Shown)
— Flange Bolts ⁄ "-20 x
1
4
— T-Bolts ⁄ "-20 x
1
4
— Hex Huts ⁄ "-20 ....................................... 2
1
4
— Flange Screw 10-24 x
B. Wall Bracket ............................................... 1
C. Remote ....................................................... 1
D. Motor/Impeller Assembly ............................ 1
E. Inlet Adapter 6" x 4" x 4" ............................ 1
F.
Collection Bag ............................................ 1
Box 2 (Figure 5)
G. Bag Clamp 15"............................................ 1
H. Filter Cleaning Handle ................................ 1
I.
Canister Filter ............................................. 1
B
C
D
F
Figure 5. Inventory.
NOTICE
If you cannot find an item on this list, care-
fully check around/inside the machine and
packaging materials. Often, these items get
lost in packaging materials while unpack-
ing or they are pre-installed at the factory.
Model G0944/G0944HEP (Mfd. Since 03/21)
Qty
⁄ " ......................... 6
3
4
⁄ " .................................. 2
3
4
⁄ " ....................... 1
3
8
Qty
E
G
I
H