Digital Set-Up - Sony Bravia KDL-40X4500 Operating Instructions Manual

Digital Set-up

Digital Auto Tuning
Programme Sorting
Digital Manual Tuning Tunes the digital channels manually. This feature is available when "Digital Auto
46
GB
Audio Filter Improves the sound of individual channels when distortion
occurs in mono broadcasts. Sometimes a non-standard
broadcast signal can cause sound distortion or intermittent
sound muting in mono programmes.
If you do not experience any sound distortion, we recommend
that you leave this option to "Off" (factory setting).
~
• You cannot receive stereo or dual sound when "Low" or
"High" is selected.
Skip Skips unused analogue channels when you press PROG +/–
to select channels. To select channels you have programmed
to skip, use the corresponding number buttons.
Decoder
Allows you to view and record the scrambled channel when
using a decoder connected directly to scart connector
~
• Depending on the country/area selected for "Country", this
option may not be available.
LNA
Improves the picture quality of the channel (noisy picture)
when the broadcast signal is very weak.
If you cannot see any improvement in the picture quality even
if you set to "On", set this option to "Off" (factory setting).
Confirm
Saves changes you have made to the "Manual Programme
Preset" settings.
Tunes in the available digital channels.
You can retune the TV after moving house, or to search for newly launched
channels.
Allows you to remove or change the order of digital channels stored in the TV.
1
Press F/f to select the channel you want to remove or move to a new position.
You can also select a channel by pressing the number buttons to enter its
three-digit channel number.
2
Remove or change the order of the digital channels as follows:
To remove a digital channel
. After a confirmation message appears, press G to select "Yes", then
Press
press .
To change the order of the digital channels
Press g, then press F/f to select the new position for the channel and press G.
3
Press RETURN.
Tuning" is set to "Antenna".
1
Press the number buttons to enter the channel number you want to tune, or
press F/f.
2
When the available channels are found, press F/f to select the channel you
want to store, then press
3
Press F/f to select the channel number where you want to store the new
channel, then press
Repeat the above procedure to tune other channels.
AV1, or / AV2 via a VCR.
.
.
/