Table of Contents
Advertisement
Setting the pair
In order to establish the wireless connection between the receiver and Bluetooth cellphone, the receiver and
cellphone pair must first be registered.
Before operating the units, check the following points.
• Has the pairing of the receiver and cellphone you are about to use been registered? (Refer to page 18.)
Press and hold the MIC button on the receiver for 2 seconds.
The receiver's power is turned on, and its lamp (red) starts blinking slowly.
Establish a "hands-free" connection by performing the Bluetooth
connection operation on your cellphone.
• When the pair setting is completed, the receiver's lamp (blue) starts blinking
slowly.
• To establish pairing again after pairing has been released or the receiver's
power was turned off, press the MIC button on the receiver once, then check the
connection with the cellphone.
Note:
• For further details on the Bluetooth connection operation, refer to the operating instructions of your cellphone.
Hands
-free
19
Advertisement
Table of Contents
