Advertisement
Vocollect SRX/SRX2 Quick Start Guide
Manually pairing the headsets and Talkman devices
With first use, manually pair the headsets with Talkman devices. You must manually pair the headsets with
devices the first time the hardware is used together. Once manually paired, a headset automatically pairs with
the device if the parameter SrxAutoPairEnable is set to 1 in the device profile.
Manual pairing is described briefly below. See the Vocollect Hardware Reference for more information on
pairing headsets and devices.
Manually pairing an
Make sure the headset is powered off; the Talkman device is not in a charger and that there is not a wired
headset connected to it; and the Talkman device is in sleep mode (its green LED indicator is flashing). If the
LED indicator is solid green, press the Play/Pause button to put it in sleep mode.
1. Press and hold the Plus and Minus buttons on the headset until the LED indicator flashes steadily. The
headset is now in low-power pairing mode.
2. Press and hold the Plus and Minus buttons on the Talkman device for two seconds and then
immediately hold the headset and device so they are within six inches of each other but not touching.
The blue LED indicator on the Talkman device turns on. After about 20-30 seconds (sometimes
longer), the headset beeps three tones ascending in pitch and the LED indicator flashes less rapidly.
This indicates pairing has taken place.
3. Put on the headset.
4. Verify that the number you hear matches the serial number on your Talkman device and press the
Play/Pause button to confirm.
5. Press the Play/Pause button to begin working.
Manually pairing an
Make sure that the Talkman device:
•
is not in a charger,
•
is not connected to a wired headset, and
•
is in sleep mode (its green LED indicator is flashing). If the LED indicator is solid green, press the
Play/Pause button to put it in sleep mode.
1. Turn on the headset. The LED indicator is solid green. The headset remains in pairing mode for ten
minutes.
2. Press and hold the Plus and Minus buttons on the Talkman device for two seconds to manually initiate
a search for wireless headsets.
3. Immediately hold the headset and Talkman device so they are within six inches of each other but not
touching.
The blue LED indicator on the Talkman device turns on. After 20 to 30 seconds, the headset beeps
three ascending tones and its LED indicator flashes blue. This indicates pairing has taken place.
4. Put on the headset.
5. Verify that the number matches the serial number on the Talkman device and press the Play/Pause
button to confirm.
If you need to attempt the pairing again, re-enter pairing mode by press the Plus and Minus buttons on
the Talkman device again.
6. Press the Play/Pause button to begin working.
Using a listening kit with SRX/SRX2 headsets
A listening kit can be connected to a device in order to listen to the audio output of the device or the dialog
between the device and operator for training or demonstration purposes.
To setup this feature, set the SrxSupervisorAudioEnable parameter in the device profile or the task package
loaded onto the device to "1" to listen to the device and operator dialog or "2" to listen to just the device output
(recommended).
If not using a listening kit, ensure that SrxSupervisorAudioEnable is set to "0" (default), for optimal performance.
© 2012-2105 Honeywell International Inc. All rights reserved.
SRX
headset with a Talkman device
SRX2
headset with a Talkman device
ETP.QS.5008.2015.01
Advertisement
