Table of Contents
Advertisement
5.3 Setting and changing the
time
You must set the time before you
operate the oven.
When you connect the appliance to the
electrical supply or after a power cut,
flashes.
Press the
time.
After approximately 5 seconds, the
flashing stops and the display shows the
time of day.
To change the time, press
again until
5.4 Preheating
Preheat the empty oven before first use.
6. HOB - DAILY USE
WARNING!
Refer to Safety chapters.
6.1 Hob control panel
Use the sensor fields to operate the appliance. The displays, indicators and sounds
tell which functions operate.
Sen‐
sor
field
1
-
or
to set the correct
again and
starts to flash.
1
9
Function
Heat setting display
Preheat the two ovens
before first use. Heat up one
oven at a time.
Set the functions listed
below, if applicable.
1. Set the function
temperature to 250ºC.
2. Let the oven operate for 1 hour.
3. Set the function
temperature to 250ºC.
4. Let the oven operate for 15 minutes.
5. Set the function
temperature to 250ºC.
6. Let the oven operate for 15 minutes.
7. Turn off the oven and let it cool
down.
Accessories can become hotter than
usual. The oven can emit an odour and
smoke. Make sure that the airflow in the
room is sufficient.
2
3
8
Comment
To show the heat setting.
ENGLISH
. Set the
. Set the
. Set the
4
5
6
7
11
Advertisement
Table of Contents
