Casio Celviano AP-260 User Manual page 39

Assembling the Stand
1.
Attach side panels A and B to crosspiece D.
Secure the side panels using four E screws.
• When installing parts 2, slide the brackets 3 into the
slots in either end of crosspiece D. If the brackets 3
are not inserted into the ends of the crosspiece D as
far as they will go, the screws E will not be able to
enter into the screw holes of the brackets 3, which
can strip the threads of the screws.
• Cover the screw heads with the caps J.
J
A
E
3
2
2.
Slide back panel C into the grooves 4 of the
side panels.
IMPORTANT!
• Make sure that the back panel C is positioned
correctly as described below when installing it.
– Before sliding back panel C into place, make sure
that the widely spaced screw holes along the
bottom of the panel are on the left (when viewed
from the front of the stand), and the narrowly
spaced holes are on the right.
Wide
C
4
EN-38
J
D
E
B
Narrow
3.
Use the two screws I to secure the top left
and right edges of the back panel C to the
brackets 5 of side panels A and B .
• At location 6 , slip the clip G onto to the screw I
before installing the screw.
6
G
I
4.
Next, secure the bottom of the back panel C
with the six screws F .
B
5.
Adjust the height adjustment screw 7 to
provide support so crosspiece D does not
bow downwards when the pedals are
pressed.
D 7
IMPORTANT!
• Pressing the pedals without adjusting height
adjustment screw 7 can result in damage to
crosspiece D . Always make sure you adjust height
adjustment screw 7 before operating the pedals.
5
I
A
C
F