Casio Celviano AP-260 User Manual page 30

Parameter List
■ Tones
Parameter Settings
Reverb Off (OFF), 1 to 4
bp
(REVERB) Default: 2
Tone selection See page EN-10.
bq
Default: GRAND
PIANO
(CONCERT)
Chorus Off (OFF), 1 to 4
br
(CHORUS) Default: Off
Brilliance –3 to 0 to 3
bt
(BRILLIANCE) Default: 0
Layer balance –24 to 0 to 24
cn
Default: –10
Duet pan Off (OFF), On (ON)
cq
Default: Off
Bass damper Off (OFF), On (ON)
cr
effect Default: Off
Damper noise Off (OFF), On (ON)
cs
Default: On
Operation
Type
Description
(page
EN-27)
A Specifies the reverb of notes.
(page EN-13)
A Assigns a tone to the keyboard.
(page EN-10)
D Controls the breadth of notes.
(page EN-13)
B Specifies the brilliance of notes.
Pressing [+] makes notes brighter
and harder. Pressing [–] makes
notes mellower and softer.
B Specifies the volume balance
between the main tone and the
layered tone. (page EN-12)
D When turned on, outputs the left
side keyboard tone from the left
speaker and the right side
keyboard tone from the right
speaker while duet is turned on.
(page EN-16)
D When turned on and the BASS
(LOWER) tone is selected, pressing
the damper pedal or sostenuto
pedal will apply sustained
reverberation to the BASS
(LOWER) tone. (page EN-11)
D Enables/disables damper noise
output. (page EN-14)
Configuring Settings with the Keyboard
Remarks
• To return the setting to its initial default (0),
press [+] and [–] at the same time.
• To return the setting to its initial default
(–10), press [+] and [–] at the same time.
• Supported only when a piano tone is being
used. Reverb is not applied when this
parameter is turned on.
EN-29