Chute Gear Replacement - Toro Power TRX Commercial 1428 Service Manual

Chute and Face Gear Cover Installation (continued)

Chute Gear Replacement

Chute Gear Removal
Chute Gear Installation
POWER TRX™ HD Service Manual
3440-740 Rev A
2. Install the front of the cover into position. Secure with a screw.
1. Park the machine on a level surface. Stop the engine, wait for all moving
parts to stop and remove the key.
2. Remove the Phillips head screw on the face gear cover.
3. Raise the front of the cover and slide towards the rear.
4. Remove the locknut from the bottom of the 3 shoulder screws (1/4 - 20 x 5/8
inch, 5/16 - 18 x 1 1/2 inch, and 5/16 - 18 x 2 1/2 inch).
5. Disconnect the latch cable from the cable anchor.
6. Raise the front of the face gear and slide towards the chute rod.
7. Remove the (5/16 -18 x 2 1/2 inch) shoulder bolt from the chute gear.
8. Remove the 2 (1/4–20 x 1/2 inch) screws securing the gear to the bracket.
Remove the gear.
Note: A plastic spacer is under the bracket.
1. Attach the chute gear to the bracket and secure with 2 (1/4–20 x 1/2 inch)
screws.
2. Place the spacer side up on the support tube, then set the gear and bracket
down on it. The (5/16 -18 x 2 1/2 inch) shoulder bolt goes through and is
secured with the washer and locknut.
3. Slide the face gear mount on the chute rod, if removed. Slide the face gear
on the chute rod.
4. The face gear has a rib molded into it and the chute gear has 2. Line up the
ribs and place the face gear mount onto the support tube.
5. Install the end of the latch cable in the latch and install the cable conduit
into the cable anchor.
Page 10–5 Discharge Chute: Service and Repairs