Chute And Face Gear Cover Replacement - Toro Power TRX Commercial 1428 Service Manual

Chute and Face Gear Cover Replacement

Chute and Face Gear Cover Removal
Chute and Face Gear Cover Installation
Discharge Chute: Service and Repairs
1. Park the machine on a level surface. Stop the engine, wait for all moving
parts to stop and remove the key.
2. Remove the (1/4–20 x 5/8 inch) bolt securing the cable to the clamp and
deflector link. Remove the cable from the clamp and deflector link.
g263135
3. Remove the Phillips head screw retaining the gear cover. Lift the front of
the cover and slide towards the rear.
g263348
4. Remove the (5/16–18 x 2 1/2 inch) bolt on the chute gear.
5. Remove the chute.
1. Install the chute. Secure with a (5/16–18 x 2 1/2 inch) bolt on the face gear.
Figure 74
Figure 75
Page 10–4 POWER TRX™ HD Service Manual
3440-740 Rev A