Blower Safety Warnings; Functional Description; Operation - Makita M4000 Instruction Manual

8. Keep handles and grasping surfaces dry,
clean and free from oil and grease. Slippery
handles and grasping surfaces do not allow for
safe handling and control of the tool in unexpected
situations.
When using the tool, do not wear cloth work
9.
gloves which may be entangled. The entangle-
ment of cloth work gloves in the moving parts may
result in personal injury.
Service
Have your power tool serviced by a qualified
1.
repair person using only identical replacement
parts. This will ensure that the safety of the power
tool is maintained.
2. Follow instruction for lubricating and chang-
ing accessories.

BLOWER SAFETY WARNINGS

1. Always use protective goggles, a cap and
mask when using the blower.
2. Never point the nozzle at anyone in the vicinity
when using the blower.
3. Warning - Electric shock could occur if used
on wet surfaces. Do not expose to rain. Store
indoors.
Never block suction inlet and/or blower outlet.
4.
Increased motor revolution may cause danger-
ous fan breakage.
The blower is not intended for use by young
5.
children or infirm persons without supervision.
Young children should be supervised to
6.
ensure that they do not play with the blower.
SAVE THESE INSTRUCTIONS.
WARNING: DO NOT let comfort or famil-
iarity with product (gained from repeated
use) replace strict adherence to safety
rules for the subject product. MISUSE or
failure to follow the safety rules stated in
this instruction manual may cause serious
personal injury.
FUNCTIONAL
DESCRIPTION
CAUTION:
• Always be sure that the tool is switched off and
unplugged before adjusting or checking function
on the tool.
Switch action
CAUTION:
• Before plugging in the tool, always check to see
that the switch trigger actuates properly and
returns to the "OFF" position when released.
► Fig.1: 1. Switch trigger 2. Lock button
To start the tool, simply pull the switch trigger. Release
the switch trigger to stop.
For continuous operation, pull the switch trigger and
then push in the lock button, and then release the
switch trigger.
To stop the tool from the locked position, pull the switch
trigger fully, then release it.
Air volume adjusting dial
► Fig.2: 1. Air volume adjusting dial
Air speed and volume can be adjusted without positive
stops by turning the air volume adjusting dial.
To obtain high speed and increase volume, turn the
air volume adjusting dial to the A direction shown in
the figure (for the bigger number). Turn the air volume
adjusting dial to the B direction (for the smaller number)
to obtain low speed and to decrease the air volume.
ASSEMBLY
CAUTION:
• Always be sure that the tool is switched off and
unplugged before carrying out any work on the
tool.
Installing or removing the nozzle
► Fig.3: 1. Nozzle 2. Pin 3. Blower outlet 4. Notch
Align the pin protruding inside the nozzle with the notch
on the tool, push the nozzle to the blower outlet and
then securely turn the nozzle clockwise.
To remove the nozzle, turn counterclockwise and pull
it out.
Installing the sash nozzle
► Fig.4: 1. Nozzle 2. Sash nozzle
Sash nozzle is convenient for operation in a sash rail,
corner or tight place between cabinets. Secure the sash
nozzle by inserting it into the nozzle from the back of
the nozzle.
Install the nozzle with the attached sash nozzle.
► Fig.5
Sash nozzle storage
► Fig.6: 1. Sash nozzle
When not in use, the sash nozzle can be conveniently
stored at the bottom of the tool as shown in the figure.

OPERATION

Blowing
► Fig.7
Point the tool to the object to be blown off and turn on
the tool.
5 ENGLISH