U-Line H-3619 Quick Start Manual

Counter high storage cabinet

Hide thumbs Also See for H-3619:

Download this manual

H-3619

COUNTER HIGH

STORAGE CABINET

PAGE 1 OF 5

1-800-295-5510

uline.com

Tools needed

CAUTIon! some parts may have sharp

edges. Take care when handling various

pieces to avoid injury. For your safety,

wear work gloves when assembling.

11/32" Nut Driver

(Included)

Flathead Screwdriver

Rubber Mallet

0215 IH-3619

Page 1 π H-3619 1-800-295-5510 uline.com COUNTER HIGH STORAGE CABINET Tools needed 11/32" Nut Driver (Included) Flathead Screwdriver Rubber Mallet CAUTIon! some parts may have sharp edges. Take care when handling various pieces to avoid injury. For your safety, wear work gloves when assembling.
Page 2: Handle Assembly
pArTs prImAry Assembly HAndle Assembly desCrIpTIon QTy. desCrIpTIon QTy. Back Panel Locking Handle with Keys Left Side Panel (Set) Locking Cam Right Side Panel Sill Locking Bar (Set) Header Lock Bar Guide Shelf Cotter Pin Left Door Dummy Handle Right Door Stiffener Hinge Pin Bolts (32 x 3/8")
Page 3 Assembly InsTrUCTIons AssemblIng CAbIneT 4. Insert two bolts through the outside holes on each end of the sill (4). Attach the nuts, but do not tighten. 1. Place the back panels (1) on a protected surface. Place the sill between the side panels at the front The flanges should be facing upward.
Page 4 Assembly ConTInUed 7. Set the unit upright and insert the other shelves, 10. Lay the stiffener (9) across the top of the unit. Align facing the edge with no slots toward the front of the the four holes with the holes on the left and right cabinet.
Page 5: Attaching Handle
Assembly ConTInUed ATTACHIng HAndle 4. Hold the lock bars in position while sliding the lock bar guide (17) over the lock bar ends and through the door 1. Place the locking handle (14) on the right hand door slots. (See Figure 14) and fasten with two slotted bolts and lock washers.