When The Low/Status Lamp Glows - Panasonic ES-LV97 Operating Instructions Manual

► When the water does not drain from the cleaning tray
• Do not tilt the self‑cleaning recharger to pour out
water. Doing so may cause the cleaning liquid in the
cleaning liquid unit to spill or cause the self‑cleaning
recharger to malfunction.
• Beard trimmings may clog the drain at
the bottom of the cleaning tray.
In this case, you cannot clean or dry the
shaver.
1. Be sure to remove the AC adaptor
from the self‑cleaning recharger.
2. Place the self‑cleaning recharger on a
flat surface, and push the beard
trimmings down through the drain (b)
with a toothpick etc.
►Replacement parts
Replacement parts are available at your dealer or
Service Center.
System outer foil
Replacement parts
for ES‑LV97
Inner blades
Special Detergent for Shaver Cleaning &
Charging System

When the LOW/STATUS lamp glows

It indicates that the cleaning liquid is due for
replacement when the LOW lamp or STATUS lamp
glows for approximately 5 seconds when the SELECT
button is pressed.
Lamp on the self-
cleaning recharger

The LOW lamp glows.
WES9173
The STATUS lamp
WES9170
glows.
WES4L03
Content of notification
Replacement of the
cleaning liquid is required in
approximately 7 days.
Prepare the detergent.
Replace the cleaning liquid.
(Modes other than the
"AUTO" mode can be used
even if it is not replaced.)
If you think the replacement
should not be due yet.
• Is the cleaning liquid unit
correctly attached?
• Is the self‑cleaning recharger
placed in a level surface?
• Is the self‑cleaning
recharger used outside the
range of the recommended
usage temperature?
(Only "Charge" mode can
be used.)
21