Philips EP4010 User Manual page 21

English
22
Problem
The drip tray fills up
quickly.
The 'coffee grounds
container full' icon
remains displayed.
I cannot remove the brew
group.
I cannot insert the brew
group.
The coffee is watery.
Coffee is leaking from the
coffee dispensing spout.
Cause
This is normal. The machine
uses water to rinse the internal
circuit and brew group. Some
water flows through the internal
system directly into the drip
tray.
You emptied the coffee grounds
container while the machine
was switched off.
You placed back the coffee
grounds container too fast.
The brew group is not in the
correct position.
You have not removed the
coffee grounds container.
The brew group is not in the
correct position.
The machine is still in the
descaling procedure.
The grinder is set to a too
coarse setting.
The coffee exit duct is clogged.
The machine is performing its
self-adjustment procedure.
The brew group is dirty or needs
to be lubricated.
The coffee dispensing spout is
clogged.
Solution
Empty the drip tray when the 'drip tray
full' indicator pops up through the drip
tray cover. Place a cup under the
dispensing spout to collect rinsing water.
Always empty the coffee grounds
container while the machine is switched
on. If you empty the coffee grounds
container when the machine is switched
off, the coffee cycle counter is not reset.
Do not place back the coffee grounds
container until the display message
prompts you to put it back.
Close the service door. Switch the
machine off and back on again. Wait for
the 'machine ready' screen to appear
and then remove the brew group.
Remove the coffee grounds container
before you remove the brew group.
Reset the machine in the following way:
place the drip tray and the coffee
grounds container back. Leave the brew
group out. Close the service door and
switch the machine on and off. Then put
the brew group in the correct position
(see 'Reinserting the brew group') and
reinsert it in the machine.
You cannot remove the brew group
when the descaling procedure is in
progress. First complete the descaling
procedure and then remove the brew
group.
Adjust the grinder to a finer setting.
Clean the coffee exit duct with the
handle of the measuring spoon or a
spoon handle. Then switch the
appliance off and on again.
Brew a few cups of coffee.
Clean and lubricate the brew group.
Clean the coffee dispensing spout and
its holes with a pipe cleaner.