Operation; Maintenance - Makita XBU02 Instruction Manual

2. Slide in the long nozzle, and turn it clockwise until
the triangle markings on the long nozzle and the
housing meet each other.
The length of the nozzle can be adjusted by changing
the locking position.
Installing the flat nozzle or extension nozzle
Optional accessory
The extension nozzle / flat nozzle can be installed on
the tip of the long nozzle in the same way as above.
Installing the gutter nozzle
Optional accessory
The gutter nozzle can be installed on the blower. The
adapter pipe designed exclusively for this model is
required to install the gutter nozzle.
For more details, refer to the instruction manual pro-
vided with the gutter nozzle.
Attaching the shoulder strap
Optional accessory
CAUTION:
When you use the tool in combination of
the backpack-type power supply such as portable power pack,
do not use the shoulder strap included in the tool package.
If you put on the shoulder strap included in the tool
package and the shoulder harness of the back-
pack-type power supply at the same time, removing the
tool or backpack-type power supply is difficult in case of
an emergency, and it may cause an accident or injury.
Hook the shoulder strap onto the hanger of the tool.
Before use, adjust the length of strap so that it is easy
to work with it.

OPERATION

Blowing
CAUTION:
• Do not place the blower on the ground while it is
switched on. Sand or dust may enter from suc-
tion inlet, and they may result in personal injury.
Hold the blower firmly with a hand and perform the
blowing operation by moving it around slowly.
When blowing around a building, a big stone or a vehi-
cle, direct the nozzle away from them.
When performing an operation in corner, start from the
corner and then move to wide area.

MAINTENANCE

CAUTION:
• Always be sure that the tool is switched off and
the battery cartridge is removed before attempt-
ing to perform inspection or maintenance.
• Never use gasoline, benzine, thinner, alcohol or the
like. Discoloration, deformation or cracks may result.
Cleaning
From time to time, wipe off the outside of the tool using
a cloth dampened in soapy water.
7 ENGLISH