Honeywell Limitless WLS Series Quick Start Manual page 6

Limitless™ WLS Series
Single Switch Adapter
WLS Single Switch Adapter battery activation (see Figures 6 and 7):
Tools required: Slotted or Phillips screwdriver
Step Action
1
If applicable, remove the two screws  on the housing cover.
2
Using a finger, press down slightly on the battery top  and remove the battery insulator . Insure that the battery is prop-
erly seated and making good contact.
3 Replace cover and retighten screws or immediately proceed to Section 1.4 Pairing Mode.
Figure 6. Limitless™ WLS Single Switch Adapter Hous-
ing
1
1
6 Honeywell Sensing and Control
Figure 7. Limitless™ WLS Single Switch Adapter Bat-
tery and Insulator
2
50081314
ISSUE 1
3