Transmission Maintenance - Husqvarna Rider 13 AWD Workshop Manual

Method 2
1 = Shaft
2 = Lock nut
If the drive shafts do not rotate backwards
despite the fact that the hexagonal shaft has
rotated a full revolution, the neutral position is
to be adjusted in the following manner:
• Turn the shaft slowly counter-clockwise
until the drive shafts begin rotating
forwards.
• Turn the shaft slowly clockwise until the
drive shafts stop rotating forwards and
make a mark on the transmission
housing (FS) and shaft.
• Turn the shaft clockwise 8° from the
mark on the transmission housing.
• Hold the shaft still (N=8) and tighten the
lock nut (N=17).

Transmission Maintenance

Oil Change
Most homeowners with gardens do not have
the tools or experience needed to change the
transmission oil. The transmission probably
has a longer life than the rider itself, which
means that being able to change the oil is not
of major concern to the average consumer.
The lifespan of the transmission increases,
however, if the oil is changed.
When the rider is used commercially, we
recommend changing the oil first after 50 hours
of use and then every 200 hours or at least
once a year.
IMPORTANT INFORMATION
Used oil is an environmental hazard and
must not be disposed of on the ground or
in nature; it should always be disposed of
at a workshop or appropriate disposal
location.
Avoid skin contact; wash with soap and
water in case of spills.
Remember cleanliness. Follow the instruc-
tions in the hydraulic system chapter.
94
English-
REPAIR INSTRUCTIONS
Oil tank
6012-062
6012-048