Required Tools
Package Contents
Environmental Requirements
© Copyright Lenovo 2018
You need the following tools or equipment to install the NE10032O:
Standard flat‐blade screwdriver
#2 Phillips screwdriver
Electrostatic discharge wrist strap
The basic NE10032O package contains the following items:
One ThinkSystem NE10032O unit with rear‐to‐front airflow
One two‐post mounting kit for standard 19" equipment racks:
Two mounting brackets
Screws to attach brackets to the switch unit
Screws to attach the switch unit to the equipment rack
One console cable kit that includes:
One RJ45 to DB9 console cable
One Micro‐USB Type B to USB Type A console cable
One Micro‐USB Type A to USB Type A cable
One power cord retention bracket
One Important Notices document
One Warranty Information document
For a list of compatible switch components and options (such as rack‐mounting kits,
modules, cords, and cables), see the Lenovo Networking Catalog.
This section describes the basic environmental requirements for the NE10032O.
Make sure the location where you install the switch meets the following
requirements:
Install the switch unit in a dry, clean, well‐ventilated area.
Provide adequate space in the front and back of the switch unit, to ensure proper
air flow.
Make sure that an adequate grounded power supply is within reach of the
switch unit.
Make sure that twisted‐pair cable is routed away from power lines, fluorescent
lighting fixtures and other sources of electrical interference.
Chapter 3: Installing NE10032O Hardware and Options
29