Synchronizing With External Sync Signals; Inputting External Sync Signals; Enabling External Synchronization; Troubleshooting - Sony ZRD-1 Operating Instructions Manual

Synchronizing with
External Sync Signals

Inputting External Sync Signals

Input the external sync signal to the REF IN (external
reference signal input) connector on the primary controller
via a BNC cable.
Note
The following external sync signals are supported.
• HD tri-level sync (0.6 Vp-p/75Ω/negative sync)
• SD black burst/composite sync (0.286 Vp-p/75Ω/
negative sync)

Enabling External Synchronization

Caution
If a primary controller is not configured with Display
Control Software or the primary controller is not turned on,
the external synchronization cannot be enabled.
1
Select [Function] in the main screen of Display
Control Software, and then select [System Settings].
2
Select [External Sync Signal] in [Sync Signal
Selection] under [Sync] in the [System Settings]
screen.
External synchronization is enabled immediately.
Adjusting the light-up delay time for
display units
Use the slider and buttons for [Unit Light Delay] under
[Sync] to specify the light-up delay time (0 to 4000).

Troubleshooting

Be sure to conduct a check before requesting assistance. If
the problem persists, contact your local Sony
representative.
Checking the status of the system and
devices
You can check the status of the system, display controllers,
display units, and other devices in the main screen.
[System Status]
[Controller List]
[System Status]
Displays the status of the system and display controllers.
• [Operation Normal]: Operation is normal.
• [Controller Error]: Device operation has stopped due to
an error. The display controllers and display units have
entered standby mode, and picture display has stopped.
For details on the error, check the [Error] column under
[Controller List].
• [Controller Warning]: Device operation continues but a
warning (fan error, picture sync error, etc.) has occurred.
Check the details of the warning, and resolve the
problem as soon as possible.
For details on the warning, check the [Error] column
under [Controller List].
[Controller List]
Displays the status of each display controller.
[Power Status]: "-" indicates that communication
with the display controller is not possible.
[Error]: "None" indicates that there are no errors or
warning.
If an error or warning occurs, see "Error Codes"
(page 17), and resolve the problem as soon as
possible.
15
[Array Information]