Yamaha YFM700RSE Owner's Manual page 100

1
2
1. Oil filter element
2. O-ring
8. Install a new oil filter element and new O-
rings.
8
TIP
Make sure that the O-rings are properly seated.
9. Install the oil filter element cover by installing
the bolts, and then tighten them to the speci-
fied torque.
Tightening torque:
Oil filter element cover bolt:
10 Nm (1.0 m·kgf, 7.2 ft·lbf)
2
10. Install the crankcase engine oil drain bolt, the
engine oil tank drain bolt and their new gas-
ket, and then tighten the bolts to the specified
torques.
Tightening torques:
Crankcase engine oil drain bolt:
23 Nm (2.3 m·kgf, 17 ft·lbf)
Engine oil tank drain bolt:
19 Nm (1.9 m·kgf, 14 ft·lbf)
11. Install the crankcase engine oil filler cap and
its new O-ring, and then tighten the oil filler
cap to the specified torque.
Tightening torque:
Crankcase engine oil filler cap:
12 Nm (1.2 m·kgf, 8.7 ft·lbf)
12. Pour only 1.3 L (1.37 US qt, 1.14 Imp.qt) of
the specified amount of the recommended
engine oil through the engine oil tank filler
hole, and then install and tighten the oil tank
filler cap.
13. Start the engine, rev it several times, and then
turn it off.
8-16