Table of Contents
Advertisement
Initial Setup
.
Before you start
1
Put the batteries in the remote control.
2
Switch on the receiver and your TV.
,.
___
,
I
STANDBY/ON
I
SOURCE
:CD:~
•
@
._ _ _ _ .,
LL ZONE
STBY
!
'RECEIVER -SUB ZONE CONTR .OL
-
~~ED~
rr==,s~ c~~!~~\~l
3
Switch the TV input so that it connects to the
receiver.
4
Turn the subwoofer on and turn up the
volume.
A
cAUTION
•
Do not use or store batteries in direct sunlight or other
excessively hot place, such as inside a car or near a
heater. This can cause batteries
to
leak, overheat. explode
or catch fire. It can also reduce the life or performance of
batteries.
•
When inserting the batteries, make sure not to damage
the springs on the battery's
8
terminals. This can cause
batteries to leak or overheat.
•
When disposing of used batteries, please comply with
governmental regulations or environmental public
institution's
rules
that
apply in your country/area.
Automatically setting up for surround sound (MCACC)
The Auto Multi-Channel ACoustic Calibration (MCACC) setup
uses the supplied setup microphone to measure and analyze
the test tone that is outputted by the speakers.
~Important
•
Measure in a quiet environment.
1
Connect the supplied setup microphone.
•
When connecting the MCACC setup microphone, if
"Please
wait ...
" displays in the main unit display, remove
the MCACC setup microphone, then try reconnecting after
waiting for approximately one minute .
•
Set to ear height when using a tripod etc., for the
microphone.
The Full Auto MCACC
screen appears on your TV.
1:
2a.Full Auto MCACC
(iJEx~
i3
Return
~
Speaker System
: 7.2.2/5.2.217.2ch
EQ Type
:
SYMMETRY
MCACC
:
M1.MEMORY 1
Dolby Enabled Speaker:
NO
SPtoceiling
Measurement Type
:
Expert
2
Press MAIN RECEIVER on the remote control,
then press the ENTER button.
•
Automatic measuring will start.
•
Measuring will take about 3 to 12 minutes.
3
Follow the instructions on-screen.
•
Automatic setting is complete when the Home Menu
screen appears.
•
If
Reverse Phase
is displayed, the speaker's wiring(+ and-)
may be inverted. Check the speaker connections.
Even if the connections are correct,
Reverse Phase
may be
displayed, depending on the speakers and the surrounding
environment. This does not affect measurements, however,
so select
Go Next.
•
If
ERR
is displayed, check that speaker is properly connected.
•
When the power turns off, refer
to the
"Frequently asked
questions" in the booklet.
4
Make sure the setup microphone is
disconnected.
9
Hide quick links:
Advertisement
Table of Contents
