Table of Contents
Advertisement
Control reference guide
Camera front, rear, and top
REC LED
Lights up during recording.
The LED starts to flash when the
combined remaining recording time
for the cards inserted in the P2 card
slots 1 and 2 is less than 30
minutes (see page 23). The LED
can also be permanently turned off
using a Toughbook-Arbitrator Front
End Software setting. For details on
the setting procedure, see the
documentation of the Toughbook-
Arbitrator Front End Software.
Sun shade
Protects the lens from direct sunlight.
Wide conversion lens
The wide conversion lens enables a wider
viewing angle when recording video.
Backlight compensation
button
Controls the backlight compensation
function. Each push of the button
switches the function ON or OFF.
Light button
Controls the camera operation
panel illumination. Each push of the
button switches the illumination ON
or OFF.
Camera cable connector
Use the supplied camera cable to
connect the camera to the supplied
recorder.
(continued)
Zoom buttons
Control the zoom function. The W
button serves to zoom out and the
T button to zoom in.
Auto zoom button
Pressing this button causes the
camera to automatically zoom in,
pause for a certain period, and
zoom out. The zoom factor and
pause duration can be set. For
details on the setting procedure,
see the documentation of the
Toughbook-Arbitrator Front End
Software.
REC button
Pressing this button causes the
recorder to start recording.
Camera mount holes
The supplied camera mount can be
attached here.
When the wide conversion lens is
mounted, use the front hole (A).
When the wide conversion lens is
removed, use the rear hole (B).
Notes:
• Use only the wide conversion lens
that was mounted on the camera
when delivered.
• Use only the specified camera
mount positions to install the
camera.
A
B
13
Advertisement
Table of Contents
