Table of Contents
Advertisement
Advanced Features
Advanced Options
Using the remote control to operate your TV
The HS-U576 remote control can operate many of the frequently-used func-
tions of your TV. You only need one remote to operate both your VCR and TV.
The HS-U576 remote control is pre-set to operate Mitsubishi televisions, but it
can also operate TVs from other manufacturers. To set your remote control for
your particular brand of television, follow these instructions.
setting up your remote control to operate your TV
1
Turn off your TV.
2
On the HS-U576 remote control, set the VCR/TV slide switch to TV
position.
3
While holding in SP/EP, press the code button listed that corresponds to
the brand of your TV.
4
Press TV POWER on the HS-U576 remote control. Once your TV has
turned on, your remote is set up to operate your brand of TV.
If your TV does not turn on, repeat step 3 using the next code listed for the
brand of your TV.
If none of the codes listed for the brand of your TV work, then repeat step 3
several times, using a different code button until one works. The possible code
buttons are: 0, 1-9, MUTE, VOLUME ª,º, CHANNELª,º and INPUT.
You do not need to perform this set-up again until you change the batteries, set
up your remote for another brand of television, or you get a new TV.
Once you have correctly set your remote control to operate your TV, you will
be able to use the TV POWER, CHANNEL, VOLUME, and number buttons to
operate your TV.
Because of variations among models, some or all buttons may not work,
or they may operate different functions than expected for your particular
TV. If this occurs, you may need to use your TV remote control.
Sometimes manufacturers will change the remote control codes for their
products, or they will use more than one code. If this is the case, your
remote may not be able to control your TV.
When you replace the batteries in your remote, the remote may return to
its initial setting (code button 1). Repeat the steps above to reset your
remote control. If you enter a new code, the previous code will be erased.
operating your TV with the HS-U576 remote control
1
Set the VCR/TV slide switch to TV position on the HS-U576 remote
control to tell the remote that you want to operate the TV.
2
Point the remote control towards the TV and press the desired buttons.
To once again control the VCR, set the VCR/TV slide switch to VCR position.
46
IMPORTANT
IMPORTANT
Brand code
Brand of TV
buttons
Mitsubishi
1, 2, 3
Fisher
0
VOLUME ª
G.E.
Goldstar
2, 9
Hitachi
8
JVC
MUTE
Magnavox
4
NEC
2, 9
Panasonic
CHANNELª,º
Pioneer
6
Philips
4
VOLUME ª
Proscan
Quasar
CHANNELº
RCA
VOLUMEª
Sanyo
0
Sharp
3, 5
Sony
VOLUMEº
Toshiba
7
Zenith
INPUT
1
2
3
4
5
6
7
8
9
0
X 2
VCR
TV
Advertisement
Table of Contents
