Epson PhotoPC L-500V Reference Manual page 11

Do not insert objects into any openings on the charger as they may touch dangerous voltage
points or short out parts.
Never disassemble or modify the charger.
Use the charger indoors only, in a dry location. Do not expose the charger to water or excess
humidity.
Use only the type of power source indicated on the label and always supply power directly
from a standard domestic electrical outlet. Do not place multiple loads on the electrical outlet.
Be sure your AC power cord meets the relevant local safety standards.
Never insert or disconnect the power plug with wet hands.
Power supply cords should be protected from abrasion, cuts, crimping and kinking. Be sure
to place the cord to avoid any damage. Do not place objects on top of the power cord or allow
the power cord to be stepped on or run over. You should take special care to try to keep the
power cord straight at the ends and at the points where it enters and leaves the transformer.
Do not allow the AC power cord to become damaged or frayed.
Unplug your equipment from the electrical outlet and refer servicing to qualified personnel
under the following conditions:
If the power cord or plug is damaged; if liquid has entered your equipment; if your equipment
has been exposed to rain or water; if your equipment has been dropped or damaged; if your
equipment is operating abnormally or exhibits a distinct change in performance. Adjust only
those controls described in your product documentation.
Never attempt to repair this product yourself.
11
Introduction