Table of Contents
Advertisement
CHILD LOCK
When the Child Lock is engaged, the buttons
on the control panel are locked from use.
1. To turn on, press and hold the
on the control panel or press and hold the
on the remote control until a beep sounds
and the child lock icon illuminates on the
LED display panel.
2. To cancel, repeat step 1 until the child lock
icon no longer illuminates on the LED
display panel.
FILTER RESET
• The REPLACE FILTER icon will illuminate on
the LED display panel indicating that the
filter needs to be replaced.
• Replace the filter according to the directions
found under Replacing the Filter in this book.
• Once the filter is replaced, press and hold
the
button on the control panel for
10 seconds to reset. The REPLACE FILTER
icon will no longer illuminate on the control
panel display.
• The built-in timer for the filter reset is
95 days.
NOTE
For best performance, the filter should be
cleaned at least monthly as per the instructions
found in the Care, Cleaning & Storage section
of this book.
REMOTE CONTROL
The purifier fan heater comes with a remote
control. This remote control features the same
controls as the control panel on the purifier fan
heater and can be used the same way.
The control panel has an additional control
not found on the remote control. The FILTER
RESET function can be set using the control
panel only. Refer to the FILTER RESET section
of this book for more details.
LPH408_ANZ_IB_D21_FA.indd 15
LPH408_ANZ_IB_D21_FA.indd 15
To avoid misplacing your remote control, place
the remote control in the remote holder at the
back of the unit (Fig. 1).
button
Fig. 1
USING THE REMOTE CONTROL
The remote control includes 1 x CR2032
3V Lithium battery. This Lithium battery is
protected by an isolating slip. Before first
using the remote control, remove the battery
isolating slip by pulling the slip outwards away
from the remote control.
To check and/or to replace the battery, open
up the battery compartment at the back of the
remote by forming a good grip of the remote,
pushing the small arched groove to the right
and simultaneously pushing out the battery
compartment cover by pushing the rectangular
groove outwards. Insert the battery paying
attention to the polarity (+ and -) (Fig. 2).
Fig. 2
BACK OF REMOTE
15
29/1/21 11:07 am
29/1/21 11:07 am
Advertisement
Table of Contents
