Check The Printer; Connect The Printer To Your Computer; Connecting To A Pc - Epson Stylus Color 600 Quick Setup Manual

Note:
The printer is assigned to
parallel port LPT1; if you
want to use a different
port, see your Windows
documentation for
instructions.

Check the Printer

1. Turn off the printer.
2. While holding down the
printer. Then release the buttons.
3. A page prints out showing the ROM version and a
multicolor nozzle check pattern consisting of staggered
horizontal and straight vertical lines. When it's finished,
turn off the printer. If you have any problems with the test,
see Chapter 6 in your User's Guide for more information.

Connect the Printer to Your Computer

You can connect your EPSON Stylus COLOR 600 to either an
®
IBM compatible PC or an Apple
shielded parallel cable to connect to a PC or an Apple System
Peripheral-8 serial cable to connect to a Macintosh. For a
complete list of system requirements, see the Introduction of
your User's Guide.

Connecting to a PC

1. Turn off the printer and your computer.
2. Connect the cable to the printer's parallel interface; then
squeeze the wire clips together until they lock in place. (If
your cable has a ground wire, connect it now.)
®
3. Connect the other end of the cable to your computer's
parallel port and secure it as necessary.
load/eject button, turn on the
®
7
®
Macintosh . You'll need a
ground
wire