AEG SRC 4321 Manual page 13

English
54
Radio Tuning
• Press the STANDBY (POWER) button (13/27)
to switch the device on.
• Press the FUNCTION button (11/20) repea-
tedly till FM or AM is shown on the display.
FM (MHz) = Very High Frequency, AM (KHz) =
Medium Wave
• Tune the program by pressing the TUNING+/
TUNING- buttons (2). The display will show
the radio frequency and, to the left, the radio
band.
• The stereo control lamp (in the display) is
illuminated only when the selected program
is received in stereo quality. If the signal is too
poor and noise in the received program, it will
fl icker. Try to improve reception by turning and
unrolling or rolling the antenna up.
• For receiving AM programs, an antenna is
included in the device. The device can be
oriented to the signal by turning it. In this
frequency band, programs are broadcast only
in mono mode.
Alarm Function
Set Alarm
You can set two alarm times; proceed as fol-
lows:
• Press the SET AL1 button (3). The set alarm
time fl ashes on the display.
• Now press and hold the HR and MIN buttons
(7/6) to set the desired alarm time.
Note:
The digits stop fl ashing after approx. 8
seconds and the currently displayed time is
saved.
• Press the AL1 button (12); the display shows
ALARM1 and briefl y the set alarm time. The
fi rst alarm is activated.
Set Second Alarm:
• Press the SET AL2 button (5). The set alarm
time fl ashes on the display.
• Now press and hold the HR and MIN buttons
(7/6) to set the desired alarm time.
Note:
The digits stop fl ashing after approx. 8
seconds and the currently displayed time is
saved.
• Press the AL2 button (4); the display shows
ALARM2 and briefl y the set alarm time. The
second alarm is activated.
Press the STANDBY (POWER) button to turn
off the alarm until the next day.
Deactivate Alarm
• To deactivate the fi rst alarm repeatedly press
the AL1 button (12) until ALARM1 turns off on
the display.
• To deactivate the second alarm repeatedly
press the AL2 button (4) until ALARM2 turns
off on the display.
Wake Up to Radio
• Press the STANDBY (POWER) button to turn
the device off after setting the alarm.
• Repeatedly press the AL1 or AL2 button until
RADIO is displayed. The current frequency
is displayed. Press TUNING+/TUNING- (2) to
tune into a different radio station.
Note:
You have 8 seconds to tune into a new radio
station; the displayed frequency is saved.
• The radio automatically turns on at the set
alarm time and the tuned-in radio station is
played. The volume increases slowly.
Wake Up to Buzzer
• Press the STANDBY (POWER) button to turn
the device off after setting the alarm.
• Repeatedly press the AL1 or AL2 button until
BUZZER is displayed.
• The radio automatically turns on with the
buzzer instead of a radio station at the set
alarm time. The volume increases slowly.
Wake Up to iPod
• Connect the iPod to the iPod dock (1).