Specifications - Makita DCS550 Instruction Manual

ENGLISH (Original instructions)
1-1. Red indicator
1-2. Button
1-3. Battery cartridge
2-1. Star marking
3-1. Lever
4-1. A position
4-2. Cutting line
4-3. Base
5-1. Switch trigger
5-2. Lock-off lever

SPECIFICATIONS

Max. Cutting depth
No load speed (min
• Due to our continuing program of research and development, the specifications herein are subject to change without notice.
• Specifications and battery cartridge may differ from country to country.
• Weight, with battery cartridge, according to EPTA-Procedure 01/2003
Intended use
The tool is intended for cutting in mild steel and
aluminum only with appropriate saw blades.
Noise
The typical A-weighted
according to EN60745:
Sound pressure level (L
Uncertainty (K) : 3 dB (A)
The noise level under working may exceed 80 dB (A).
Wear ear protection
Vibration
The vibration total
determined according to EN60745:
Work mode : cutting metal
Vibration emission (a
Uncertainty (K) : 1.5 m/s
The declared vibration emission value has been
•
measured in accordance with the standard test
method and may be used for comparing one tool
with another.
The declared vibration emission value may also be
•
used in a preliminary assessment of exposure.
Explanation of general view
6-1. Lamp
7-1. Shaft lock
7-2. Hex wrench
8-1. Hex bolt
8-2. Outer flange
8-3. Saw blade
8-4. Inner flange
8-5. Cup washer
9-1. Hex wrench
10-1. Front grip
Model
Blade diameter
-1
)
Overall length
Net weight
Rated voltage
noise level determined
) : 78 dB (A)
pA
value (tri-axial vector
2
) : 2.5 m/s
h,M
2
ENE066-1
WARNING:
The vibration emission during actual use of the
•
power tool can differ from the declared emission
value depending on the ways in which the tool is
ENG905-1
used.
Be sure to identify safety measures to protect the
•
operator that are based on an estimation of
exposure in the actual conditions of use (taking
account of all parts of the operating cycle such as
the times when the tool is switched off and when it
is running idle in addition to the trigger time).
For European countries only
ENG900-1
EC Declaration of Conformity
sum)
We Makita
manufacturer declare that the following Makita
machine(s):
Designation of Machine:
Cordless Metal Cutter
Model No./ Type: DCS550
ENG901-1
are of series production and
Conforms to the following European Directives:
2006/42/EC
And are manufactured in accordance with the following
standards or standardised documents:
EN60745
3
10-2. Rear handle
10-3. Base
11-1. Cutting line
11-2. Base
11-3. Sight grooves
12-1. Clamping screw
12-2. Rip fence (Guide rule)
13-1. Limit mark
14-1. Brush holder cap
14-2. Screwdriver
DCS550
136 mm
51 mm
3,600
348 mm
2.6 kg
D.C. 18 V
Corporation as the
ENH101-16
responsible