Installation Procedures; Client Bridge Configuration - GE MobileLink CB-1000 Installation And Troubleshooting Manual

Installation Procedures

Client Bridge Configuration

4
Installation Procedures
127(
As you configure the bridge, be sure that the information is
accurately recorded on the Service Label (one provide with each
client bridge) and that this information matches the information in
the Configuration Capture file (2002783-067) and the information
entered during the configuration. After configuration is done and the
information has been entered on the label, you will be asked to apply
the label to the bottom of the client bridge bracket assembly.
1. Connect the client bridge to a computer using a straight through
network cable. Plug in the AC adapter for power.
127(
In order for the symbolst.exe application to work properly, the
computer must be connected ONLY to the client bridge. Any
other network communications will cause errors with the
application.
If the computer is unable to access the client bridge, see
"Troubleshooting"
2. Insert the MobileLink CD.
3. Execute the SymbolStationManager program by double-clicking the
symbolst.exe file.
MobileLink
2002783-060
Service Label
on page 27 for a suggested remedy.
13A
Revision D