The Content Of This Manual Is Very Helpful To The Users - Omega BSID346X Instruction Manual

The safety supply hose consists of the double walls. The hose's sy stem guarantees its intervention b y blocking the
flow of water in case of the supply hose breaking a nd when the air space between the supply hose itself a nd the outer
corruga ted hose is fu ll of water.
A hose that a ttaches to a sink spray can burst if it is installed on the same water line as th e d ishwash er. If your sink
has one, it is recommended that the hose be d isco nnected and the hole plu gged .
1
Turn off the water.
2
Release the water pressure by depressing the pressure release button. This relieves water pressure and protects you, and the
room, from severe splashing.
3
Unscrew the safety supply hose from the faucet.
Connect the cold water supply hose to a thread ed 3/4(inch) conn ector and make sure that it is fastened tightly in place.
If th e water p ipes are new or have not been use d for an e xtended period of time, let the water ru n to make sure that th e
water is clear and free of impurities. If this preca ution is not taken, there is a risk th at the water inlet can get blocked
and damage the appliance.
The following things should be checked before starting the dishwasher.
1
The dishwasher is level and fixed properly
2
The inlet valve is open
3
There is no leakage at the connections of the conducts
4
The wires are tightly connected
5
The power is switched on
6
The inlet and drain hoses are knotted
7
All packing materials and printings should be taken out from the dishwasher
After installation, please make sure to keep this manual.

The content of this manual is very helpful to the users.

Improper connection of the equipment earthing conductor can result in the risk of an
electric shock.
Check with a qualified electrician or service representative if you are in doubt whether the
appliance is properly earthed.
Do not modify the plug provided with the appliance. If the plug does not fit properly to the
outlet, please have a qualified electrician to install a proper outlet.
Th e applian ce must be connecte d to the water mains using new hose-sets.
Th e old hose-sets should no t be reused.
Water pressure must be between 0,04 MPa and 1 MPa. If the pressure is below the
minimum consult our Service Department fo r advice.
1
Pull The safety supply hoses completely out from the storage compartment located at rear of
dishwasher.
2
Tighten the screws of the safety supply hose to the faucet with thread 3/4inch.
3
Turn water fully on before starting the dishwasher.