Table of Contents
Advertisement
When you press th e Start/Pause button to pause du ring washing, the running indicator will
stop blinking a nd the dishwasher will
Start/Pause
button to start.
1
A cycle that is underway can on ly be modified if it has only been running for a short time. Otherwise, the
detergent may have already be en released, a nd the appliance may have already drained the wash water.
If this is the case , the detergent dispenser mu st be refilled (see the section entitled " Loading the
Detergent " ).
2
Press the Start/Pause button, the machine will be in standby state, press the program button for more than
3
seconds
then you can change the program to the desired cycle setting (see the section entitled " Starting a wash
cycle. . ." ).
If you ope n the door
stop blinking and the buzzer will be
you close the door ,the ma chine will keep o n working after 10 seconds.
A forgotten dish can be added any time before the detergent cup opens.
1
Press the Start/Pause button
2
Open the door a little to stop the washing.
3
After the spray arms stop working,you can open the door
completely.
When the wo rking cycle has finished, the buzzer of the dishwasher will sound for 8 seconds, then stop. Turn off
the appliance using the Powe r switch button, shut off the water supply and open the doo r of the dishwasher.
Wait for a few minutes before unlo ading th e dishwasher to avoid ha ndlin g the dishes and utensils while they
are still hot and more susceptible to break age. The y will also dry better.
Switch Off the Dishwasher
The program light is on but is not blinking, only in this case the programme has ended.
1.Switch off the dishwasher by pressing the
2.Turn off the water tap.
Open the door carefully.
Hot dishes are sensitive to knocks. The dishes should therefore be allowed to cool down around 15 minutes
before removing from the appliance.
Open the dishwasher door, leave it ajar and wait a few minutes before removing the dishes. In this way they
will be cooler and the drying will be improved.
Unloading the dishwasher
It is normal that the dishwasher is wet inside.
Empty the lower basket first and then the upper one. This will avoid water dripping from the upper Basket onto
the dishes in the lower one.
Wash the arms in soapy and warm water and use a soft brush to
When following this procedure from step1 to step 3, the filter system will be removed;
clean the jets. Replace them after rinsin g them thorough ly.
when following it from Step 3 to Step 1, the filter system will be installed.
be beeping
eve ry minu te unless you press the
during a wash cycle
beeping
Power
It is dangerous to open the door when washing, because the hot water may scald you.
, the mach ine will paus e. The program light will
every minu te un less you close th e door . After
4
Add forgotten dishes.
5
Close the door
Press the
Start/Pause
6
after 10 seconds.
button.
button, the dishwasher will run
Advertisement
Table of Contents
