Lan Switch - Huawei FusionModule5000 Product Description

FusionModule5000 Smart Modular Data Center
Product Description (ECC800)
Button
Name
Default

3.4.4 LAN Switch

Figure 3-50 shows an S5320 LAN switch.
Function
Description
WiFi pairing
button
IP address reset
On the WebUI, restoring factory settings by one-click is supported. Click Maintenance >
Configuration File > Restore Factory Settings.
⚫ The monitoring module IP address restores to the default value.
⚫ The video device IP address restores to the default value.
⚫ Configuration parameters of each device restore to default values.
⚫ The smart module plan view configuration is cleared.
⚫ Alarm parameter configuration restores to default values.
⚫ The NetEco communication parameters restore to default values.
⚫ The smart module name restores to the default value.
⚫ The WiFi function is disabled.
⚫ The time and time zone restore to default values.
Operation Description
In non-WiFi pairing mode, press the
button for less than 1.2s to enter the
WiFi pairing mode.
Press and hold down the button for
3s. Then the IP address for the
ECC800 WAN_1 port will restore
to the default address 192.168.1.10.
Indicator Status
⚫ When the system
enters the pairing
mode, the RUN
indicator is
steady on.
⚫ After pairing
succeeds, the
RUN indicator
blinks just as
before WiFi
pairing.
⚫ If pairing does
not succeed for
three minutes, the
RUN indicator
blinks just as
before WiFi
pairing.
None
72