Advertisement
Caution: Installation of units is to be carried out by qualified technicians only. Install in appropriate location by checking ceiling structure and durability for
safety and accident prevention.
1. ATTACH BRACKET ARMS TO MONITOR
Model KZ-32: Invert the plasma display and lay it on a soft and flat surface. Remove all the screws securing the back cover to the chassis to have access to the
screws securing the base. Remove the four (4) M6 screws and the base completely from the plasma display. Reinstall the cover to the plasma chassis with all the
proper screws. See Fig 1.
Use the hardware chart in front of the manual to identify the appropriate bracket hardware. Mounting points on the bracket differ depending on plasma size. See the
diagram on the front of the manual. Invert the display on a soft, flat surface and locate the mounting points on the back of the plasma display. Secure the left and right
mounting arms to the plasma, making sure that the upper hook screw, nut and reference arrow are facing the outside edges of the display. See Fig 2 or 3.
NOTE: Do not over tighten the bracket mounting screws as damage to the display internal mounting threads could occur.
Arrow must face out prior
to installation
Securing the
bracket arms
Rear of plasma
Arrow must face out prior
to installation
Securing the
bracket arms
Rear of plasma
Advertisement
