Table of Contents
Advertisement
ASSEMBlY
WARNING
Do not use this product if it is not completely assembled or if any
parts appear to be missing or damaged. Use of a product that
is not properly and completely assembled or with damaged or
missing parts could result in serious personal injury.
WARNING
Do not attempt to modify this product or create accessories or
attachments not recommended for use with this product. Any
such alteration or modification is misuse and could result in a
hazardous condition leading to possible serious personal injury.
opERAtIoN
WARNING
Do not direct the light beam at persons or animals and do not
stare into the light beam yourself (not even from a distance).
Staring into the light beam may result in serious injury or vision
loss.
WARNING
Do not allow familiarity with products to make you careless.
Remember that a careless fraction of a second is sufficient to
inflict serious injury.
WARNING
Do not use any attachments or accessories not recommended
by the manufacturer of this product. The use of attachments or
accessories not recommended can result in serious personal
injury.
Operate in a well ventilated area. Do not block vents. Keep them
clear to allow proper ventilation.
ApplICAtIoNS
You may use this product for the purpose listed below:
■
To illuminate distant objects and areas requiring additional light
INStAllING BElt hooK
See Figure 1.
■
Align belt hook with right or left side screw hole.
■
Install screw to secure belt hook in place.
INStAllING/REMoVING BAttERY pACK
See Figure 2.
■
Align the raised rib on the battery pack with the groove inside
the spot light. Then slide the battery pack into the spot light.
■
Make sure the latches on each side of the battery pack snap
into place and that battery pack is secured in the product before
beginning operation.
■
Depress the latches to remove the battery pack.
NotE: This product is designed to be powered by either a 18
Volt battery pack or 12 Volt power source as described in this
6
manual.
If the light flashes during operation, try recharging and reinstalling
the battery pack.
For complete charging instructions, see the operator's manuals for
your battery pack and charger.
Battery products are always in operating condition. Therefore,
remove the battery pack when the product is not in use or when
carrying at your side.
12 Volt ADAptoR
See Figures 3 and 4.
The light may be connected to a 12 Volt power source, such as
a cigarette lighter receptacle or automotive power port. Refer to
vehicle owner's manual for location of cigarette lighter receptacle
or power port.
■
Insert the barrel plug into the port on the base of the spot light.
■
Secure the cord in the cord retainer.
■
Route the cord to the 12 Volt power source.
■
Hold the 12 Volt adaptor firmly and place connector into a
cigarette lighter receptacle or power port to energize light.
If the 12 V adapter does not fit firmly into the cigarette lighter
receptacle or power port, the receptacle may not be suitable for use
with the light. A poor connection at the base of the 12 V adapter
could lead to electrical problems in the vehicle outside of the
protections offered by the vehicle or light's fuse.
NotE: Powering the unit using a vehicle's 12 V receptacle when
the engine is not running will drain the vehicle's battery.
tURNING thE Spot lIGht oN AND oFF
See Figure 5.
Squeeze and release the switch trigger to turn the spot light on and
off.
NotE: It is not necessary to hold the switch trigger to operate the
spot light.
oVER tEMpERAtURE pRotECtIoN
If overheating occurs, the light will attempt to cool itself by dimming.
If dimming does not cool the light sufficiently, it will shut off. As soon
as the unit reaches normal operating temperature, it can be turned
on again. If it shuts off, allow approximately 10 minutes of cool-
down time before attempting to resume operation.
ADJUStING thE BRIGhtNESS
See Figure 6.
The brightness knob, located on the back of the spot light, controls
the intensity of the LED. To increase brightness, turn the knob to the
right. To decrease brightness, turn the knob to the left.
ADJUStABlE hEAD
See Figure 7.
Do not place hands or fingers between adjustable head and
handle when positioning spot light to avoid pinching your fingers
or hands.
6
WARNING
CAUtIoN
Advertisement
Table of Contents
