Honeywell GENT S4-BASE-PROGRAM Programming Instructions

Programming information
S-Quad Programming tool
(S4-BASE-PROGRAM)
This S-Quad programming tool
(S4-BASE-PROGRAM) is used test and program
S-Quad speech products.
1 x Programming base
1 x 9-way to 9-way
D type 1m lead
Definitions
Phrase - A phrase is a file that contains the
information from a wave file and additional
information such as a description of the speech or
sound.
Image - An image is a collection of Phrases and
other information that can be used to program a
sounder.
Project - A project is a description that refers to a
specific site or customer e.g. Heathrow Terminal 1
or Walkabout Inns.
Article - An Article is a part number for an image.
For example article number for the standard
English audio file for S-Quad is PA020001. For
each article number there is an associated version
number.
COMM port
9-way
D type
INPUT 100-240V ~ / 180mA / 50 - 60Hz
OUTPUT 9V
Insert the correct plug (polarity does not matter)
4188-914.01_Part 2_04/07_Programming tool
1 x PSU adaptor
/ 670mA
Plug
+
-
Red ring
Downloading software
and Image files
An S-Quad Speech product can be programmed
using a software called 'tools4sounderApp' using
image file.
Go to GentExpert web application at the
a.
following web address:
http://www.gentexpert.co.uk/ and follow the
instructions on the initial page to enter the
application.
Create a directory structure in which to store
b.
the downloaded files. Below is a suggested
directory structure for software and standard
images.
c. Find setup.exe.zip 29/07/2005 file in
GentExpert and save it to the local software
directory. Find the required image file(s) in
GentExpert and save it to the local image
directory.
Unzip the program and Run setup.exe. By
d.
default the program will install at
"C:\novar\tools\tools 4 Sounder\".
Once you have run the setup program you may
e.
need to modify the COM PORT setting in the
tools4sounder.ini file (it defaults to COM1).
The SampleRate parameter should also be
changed to 13kHz.
Damage will occur if you fail to align
sensor markings to the markings on
the programming base
Programming base
by Honeywell
j
.
S-Quad
1