Black & Decker DVC320B Manual page 8

ENGLISH
Other batteries could burst, causing
personal injury and damage.
Never attempt to charge
u
nonrechargeable batteries.
If the supply cord is damaged, it must
u
be replaced by the manufacturer or an
authorised BLACK+DECKER Service
Centre in order to avoid a hazard.
Do not expose the charger to water.
u
Do not open the charger.
u
Do not probe the charger.
u
The appliance/tool/battery must be
u
placed in a well ventilated area when
charging.
Electrical safety
Your charger has been designed for a
specific voltage. Always check that the
mains voltage corresponds to the voltage
on the rating plate. Never attempt to
replace the charger unit with a regular
mains plug.
Symbols on the charger
Read all of this manual carefully
before using the appliance.
This tool is double insulated;
#
therefore no earth wire is
required. Always check that the
power supply corresponds to
$
the voltage on the rating plate.
The charging base is intended
for indoor use only.
Labels on appliance
The following symbols appear on this ap-
pliance along with the date code.
8
(Original instructions)
Read all of this manual care-
fully before using the appli-
ance
Only use with charger
N893139 / JOD-S-150050**
N893139 / JOD-S-150050**
Features
This tool includes some or all of the following features.
1. Dust bowl cover release button
2. Dust bowl
3. Prefilter
4. Filter
5. Battery pack
6. Battery pack release button
7. Crevice nozzle
8. Brush
9. Charging stand
10. Charging adapter
11. Power button
12. Unit body
Operation
Press the Power Button (11) as shown in figure A
u
Unit starts in high speed. press button again to slow
u
speed.
Press the Power Button once more, the appliance stops
u
working.
Attaching Accessories
If you need to use the accessory Brush (8), insert the
u
Brush into the air inlet as shown in figure B and then start
the appliance.
If you need to use the accessory Crevice Nozzle (7), insert
u
the Crevice Nozzle into the air inlet as shown in figure B
and then start the appliance.
Charging
Plug the Charging Adapter (10) into the mains power
u
socket as shown in figure C.
Place the appliance into the charging stand (9) so that
u
the socket in the appliance is engaged into the plug of the
charging adapter as shown in figure D.
The charging LED indicator turns on and the appliance
u
starts to charge. When the appliance charges fully, the
charging LED indicator turns off.
Warning! Do not charge the battery off the unit to protect from
contamination.