Table of Contents
Advertisement
Installation
5.4 Wall mounting
5.4
Wall mounting
Installation
Figure 5-1
To mount the device screwed from the back on a wall, follow the steps below:
1. Prepare the drill holes for mounting. For the precise dimensions, refer to the section
"Dimension drawings (Page 85)".
2. Bring the drill holes and the cutouts for the hexagon nuts together so that they cover the
same area.
3. Place the hexagon nuts in the corresponding cutouts. The nuts cannot be turned in the
cutouts.
4. Push the screws through the drill holes and screw them to the nuts.
5. Fit the connectors for the power supply, see the section "Power supply (Page 59)".
6. Fit the connectors for the signaling contact, refer to the section "Signaling contact
(Page 64)".
Removal
To remove the device from the wall, follow the steps below:
1. Disconnect all connected cables.
2. Loosen the screws.
50
Wall mounting
Operating Instructions, 03/2021, C79000-G8976-C428-08
SCALANCE XP-200
Advertisement
Table of Contents
