Procedure For The Cdm; Removal And Reinstallation Procedures; Adjustment Procedures; Repair Procedures - Honeywell HS-700 Description And Installation Manual

SYSTEM DESCRIPTION AND INSTALLATION MANUAL

3. Procedure for the CDM

A. Removal and Reinstallation Procedures
(1) Remove the CDM.
(a) Remove power from the HSU and its interfacing equipment. Circuit breakers for
the HSU are typically located on the flight deck.
(b) Remove the HSU. Refer to paragraph 2. in this section.
(c) Loosen the two screws holding the CDM to the HSU.
(d) Remove the CDM from the HSU and place a protective cover on the connector.
(2) Reinstall the CDM.
(a) Remove the protective cover from the connector.
(b) Carefully attach the CDM to the HSU using two screws.
(c) Install the HSU. Refer to paragraph 2. in this section.
(d) Reapply power to the HSU and its interfacing equipment.
B. Adjustment Procedures
(1) Re--enter all of the configuration parameters using the CMT.
C. Repair Procedures
(1) Not applicable.
D. Return to Service Procedures
(1) Refer to test procedures in the INSTALLATION CHECK section of this manual.

4. Procedure for the Combiner/Splitter

A. Removal and Reinstallation Procedures
(1) Remove the combiner.
(a) Remove power from the HSU. Circuit breakers for the HSU are typically located
on the flight deck.
(b) Locate the combiner.
(c) Disconnect the aircraft connectors from the combiner and place protective covers
on the connectors.
(d) Remove the two screws holding the combiner in position.
Use or disclosure of information on this page is subject to the restrictions in the proprietary notice of this document.
HS--700 High Speed Data System
23- -20- -33 Page 7--3
30 Aug 2002