Advertisement
Mounting on a Recessed Drop-Ceiling T-Bar
NOTE: This mounting bracket can also be used on a flush
drop-ceiling T-bar, so the four rubber feet on the bottom of
the AP minimize ceiling tile displacement.
To mount the AP using the external T-bar bracket:
1. Position the studs on the bottom of the T-bar bracket (B) in
the mounting holes on the AP enclosure (A), and then slide
the T-bar bracket until the studs are in the narrow parts of
the AP mounting keyholes. The mounting bracket locks in
place on the AP enclosure.
FIGURE 9 Attaching the external bracket to the AP
2. Attach the locking tab (C) to one side of the T-bar and the
bracket (B) to the other side of the T-bar.
3. Slide the locking tab (C) into the bracket (B) so that it locks in
place around the T-bar. Make sure that both clasps are
gripping the T-bar.
FIGURE 10 Attaching the external bracket to the T-bar
Removing an External Bracket from a T-Bar
1. Move the ceiling tiles out of the way.
Copyright
©
2018 ARRIS Enterprises LLC. All rights reserved.
Published December 2018, Part Number 800-71989-001 Rev A
2. Slide the locking tab away from the T-bar to release the AP-
bracket assembly from the T-bar.
3. The AP bracket assembly comes away from the T-bar.
FIGURE 11 Removing the external bracket from the T-
bar
Removing the External Bracket from the AP
1. Insert the unit removal pin into the hole on the front of the
AP to unlock the mounting bracket from the AP enclosure.
2. Slide the mounting bracket toward the Ethernet ports on the
AP until it detaches from the AP.
FIGURE 12 Removing the external bracket from the AP
Attaching the GPS Antenna
The M510 includes an external GPS antenna that can be used for
device tracking in use cases such as in-vehicle Wi-Fi installations.
The GPS antenna has a magnet so that it can be attached
anywhere on the vehicle, and receives power through the RF
cable connected to the M510.
1. Connect the GPS antenna cable to the GPS cable connector
on the M510.
2. Mount the GPS antenna to any surface. The antenna can be
mounted to the roof of the vehicle for optimal GPS signal
reception, or near a window inside the vehicle if roof
mounting is impractical.
3. Log into the AP or controller web interface to verify the GPS
coordinates.
FIGURE 13 M510 external GPS antenna
For More Information
For more information on configuration, administration and
operation of the AP, refer to the Ruckus Wireless Indoor Access
Point User Guide, available from the Ruckus Support website:
support.ruckuswireless.com.
©
2018 ARRIS Enterprises LLC. All rights reserved.
ARRIS, the ARRIS logo, Ruckus, Ruckus Wireless, the Ruckus logo, and
the Big Dog design are trademarks of ARRIS International plc and/or
its affiliates. All other trademarks are the property of their respective
owners.
Page 3 of 4
Advertisement
