Advertisement
GB
Commissioning:
Use one of the available connection methods in order to establish communication between the 138091
and the TELA2 software, depending to your application.
To proceed with configurations, a device with Wi-Fi connectivity and DHCP (i.e. a laptop PC, a smartphone
or tablet) is required.
STEP 1 – Enable Gateway invitation via TELA2 software.
First, via the TELA2 software user interface, go to "Installation > Add Gateway" and click "Start". The
software will enter a mode to accept new Gateway devices (138091).
STEP 2 – Configure the Gateway to connect to local network and TELA2.
While the device is activated, open the front cover and press the "BT3" button located in the left part,
inside of the device, for 3 seconds. Avoid touching other areas of the device electronics. The "LD7" green
LED will start blinking 2 times per second, indicating the Wi-Fi Access Point ready.
LD7
BT3
"BT3" button and "LD7" LED position
Use your Wi-Fi device (laptop, smartphone) in order to connect to the Wi-Fi Access Point with the SSID
(name):
"WIRELESS_LIGHTING_GATEWAY"
Use the following password when asked:
"WIRELESSGW"
Honeywell Life Safety AS, Postboks 263, 1372 Asker
http://www.hls-nordic.com
Advertisement
