Honeywell BRDG-02M11 Installation

Check the contents
Connecting for repeater functionality
Notes:
A product is also added when it sends any message to a product that is already in the list. This is called "Auto learning".
Wait 30 seconds before removing the power supply after a product is added to the list.
Changes in the list are saved periodically every 30 seconds.
LED Indication
LED
LED
LED
LED
LED
LED
LED
Restore the factory settings: Press the reset button for 10 seconds, the power LED start blinking, release the reset button.
The repeater reboots. All learned devices will be removed.
1. Communication module.
2. Power adapter.
3. Manual.
1. Connect the communication module using the USB cable to the power adapter.
2. Connect the power adapter to the 230V power outlet. LED
3. Power LED starts blinking (repeater is now in learning mode for 5 minutes).
4. Bind the product that needs to be repeated to each other. This binding procedure is just as normal.
The Ramses repeater listens for binding messages. Once the Ramses repeater recognizes that a
product sends a binding message, this product is automatically added to an internal list of
repeated products. All messages from these products will be repeated from now on.
Function
OFF No message forwarded
blinking
Repeater forwarded a message
shortly
Repeater hasn't learned a device yet
OFF
Repeater has learned at least 1 device
ON
Repeater learned a new device,
blinking
blinks for 60s, after 60s the LED will be ON
blinking Repeater is in learning mode for 5 minutes
Repeater is in normal mode
ON
BRDG-02M11
, LED
Action
To stop the blinking press the reset button for ~1s,
the LED will now be ON. (see picture below)
When the repeater is in normal mode you need to
power cycle the repeater to reenter learning mode
1
Honeywell
RF Repeater
Installation
and LED are lit.