Table of Contents
Advertisement
2. Before Use
2.8 Drain Water Connection
Fix
the water drain hose properly to the piping. The hose has to reach a height between 80 to
100 cm at a point above the appliance bottom line. If possible, keep always drain hose fixed
to the clip at the appliance back.
WARNING!
Use only the supplied hose set for the connection.
Never reuse old hose sets.
O
nly connect to cold water supply.
Before connection, check whether the water is clean and clear.
Following connections are possible:
2.8.1 Drain hose to sink
Hang the drain hose with the U-support over the
edge
of a sink with adequate size (Fig. 2-8.1).
Protect the U-support sufficiently.
2.8.2 Drain hose to waste water connection
The internal diameter of the stand pipe with
vent-hole must be minimum 40 mm.
Put the drain hose for approx. 80 mm in the waste
water pipe.
Attach the U-support and secure it sufficiently
(Fig. 2-8.2).
2.8.3 Drain hose to sink connection
The junction must lie above the siphon.
A spigot connection is usually closed by a pad (A).
That must be removed to prevent any disfunction
(Fig. 2-8.3).
Fix the drain hose with a clamp.
CAUTION!
The Drain hose should not be submerged in water and should be securely fixed
and leak-free. If the drain hose is placed on the ground or if the pipe is at a height
of less than 80 cm, the washing machine will continuously drain while being filled
(self-siphoning).
D
rain hose is not to be extended. If necessary contact service agent.
9
2-8.2
2-8.1
2-8.3
Advertisement
Table of Contents
