Advertisement
Available languages
Available languages
Carefully square the side of the saw blade with the top
surface of the turn base using the triangular rule, try-
square, etc. by turning the 0° adjusting bolt clockwise.
Then tighten the knob firmly to secure the 0° angle you
have set.
1
► 1. Triangular rule 2. Saw blade 3. Top surface of
turn base
Check if the side of the saw blade squares with the
turn base surface once again. Loosen the screw on the
pointer. Align the pointer with 0° position in the bevel
angle scale and then tighten the screw.
45° bevel angle
NOTICE:
Before adjusting the 45° bevel angle,
finish 0° bevel angle adjustment.
Loosen the knob and fully tilt the carriage to the side
that you want to check. Check if the pointer indicates
the 45° position in the bevel angle scale.
If the pointer does not indicate the 45° position, align
it with 45° position by turning the adjusting bolt on the
opposite side of the bevel angle scale.
2
3
► 1. Left 45° adjusting bolt 2. Right 45° adjusting bolt
Adjusting the sub fences
Adjust the sub fences on the sub bases if they are not
aligned with guide fences.
1.
Loosen the bolts securing the sub fences using
the hex wrench.
2.
Place a straight rigid bar, such as a square steel
member, flat against the guide fences.
3.
While the bar is flat against the guide fences,
place the sub fences so that the face of the sub fence
becomes flat against the bar. After that, tighten the
bolts.
1
► 1. Bolt 2. Sub fence 3. Guide fence 4. Rigid bar
40 ENGLISH
1
2
3
4
2
4
Advertisement
