Bottom Cover - HP 14s Maintenance And Service Manual

Reverse this procedure to reassemble and install the display assembly components.

Bottom cover

Description
Models without eMMC modules:
Bottom cover for use in black models
Bottom cover for use in white models
Bottom cover for use in blue models
Models with eMMC modules:
Bottom cover for use in black models
Bottom cover for use in white models
Bottom cover for use in blue models
Rubber Kit for use in black models
Rubber Kit for use in white models
Rubber Kit for use in blue models
Before removing the bottom cover, follow these steps:
1. Shut down the computer. If you are unsure whether the computer is off or in Hibernation, turn the
computer on, and then shut it down through the operating system.
2. Disconnect all external devices connected to the computer.
3. Disconnect the power from the computer by first unplugging the power cord from the AC outlet and then
unplugging the AC adapter from the computer.
4. Remove the battery (see
To remove the bottom cover:
1. Position the computer upside down with the front toward you.
2. Remove the upper rubber foot (1) so you can access the screws underneath.
3. Remove the three Phillips PM2.5×6.0 screws (2) that were under the upper rubber foot.
32 Chapter 5 Removal and replacement procedures for Authorized Service Provider parts
Battery on page 34).
Spare part number
929709-001
931244-001
L00440-001
940558-001
940559-001
L00746-001
929645-001
931245-001
L00441-001