Factory Default Settings - NETGEAR Nighthawk X6 User Manual

Factory Default Settings

To reset the extender to factory default settings, you can use the Reset button on the side panel or you can
log in and click the onscreen RESET button. For more information, see
Default Settings on page 41.
The following table shows the factory default settings.
Table 2. Factory default settings
Feature
Smart Setup
WiFi communication
WiFi network name (SSID)
Security
Transmission speed
Country/region
Operating mode
Data rate in the 2.4 GHz band
Data rate in the 5 GHz low band
Data rate in the 5 GHz high band
DHCP
1
Maximum WiFi signal rate (IEEE Standard 802.11). Actual throughput can vary. Network conditions and environmental
factors, including volume of network traffic, building materials and construction, and network overhead lower actual data
throughput rate.
Nighthawk X6 AC2200 Tri-Band WiFi Range Extender
Default Settings
Enabled
Enabled
NETGEAR_EXT
Disabled
1
Auto
Varies by region
802.11a/b/g/n/ac
Max 400 Mbps
Disabled by default
(When enabled the max data rate is 866.7Mbps)
Disabled by default
(When enabled the max data rate is 866.7Mbps)
Server and client are enabled
Supplemental Information
Return the Extender to Its Factory
53