Table of Contents
Advertisement
1)
Problem
Incorrect program selection.
The filter is clogged.
Dryness Level option was set to
The load was too large.
Unsatisfactory
drying result.
The airflow slots are clogged.
Dirt on the humidity sensor in the
drum.
Dryness level not set to desired
level.
The condenser is clogged.
The filter is not locked into posi-
The loading
tion.
door does not
Laundry is trapped between the
close
door and the seal.
Not possible to
After cycle start it is not possible to
change the pro-
change the program or option.
gram or option.
Not possible to
The option you tried to select is
select an option.
not available for the selected pro-
Acoustic signal
gram.
is emitted.
Defective drum lamp.
No drum light
Unexpected du-
The drying duration is calculated
ration time on
according to load size and damp-
the display.
ness.
The water container is full.
Program inac-
tive.
Possible cause
4)
iron dry .
Remedy
Select a suitable program.
3)
Clean the filter.
Change Dryness Level option to
higher level.
Do not exceed the maximum load
size.
Clean the airflow slots at the bot-
tom of the appliance.
Clean the front surface of the
drum.
Adjust the dryness level.
Clean the condenser.
Put the filter in the correct posi-
tion.
Remove trapped items and close
the door.
Turn the tumble dryer off and on.
Change the program or option as
required.
Turn the tumble dryer off and on.
Change the program or option as
required.
Contact the service centre to re-
place the drum lamp.
This is automated — the appliance
is working correctly.
Drain the water container, push
the Start/Pause button.
ENGLISH
23
2)
5)
3)
3)
Advertisement
Table of Contents
