Makita BFL080F Instruction Manual page 7

Function
Auto-stop fastening
Delayed re-start
Warning against
insufficient fastening
Warning for battery
cartridge capacity
Checking the
remaining battery
capacity, autostop
Check the lamp, light
and beeper operation
Anti-reset of controller
Overheat
Improper clutch work
Operation error of the
switch trigger
006387
Status
This function works when the
tool has reached the preset
fastening torque and normal
tightening has been completed.
This helps overtightening to be
avoided.
For approximately one second
after auto-stop fastening, the
tool does not start even if the
switch trigger is pulled.
Insufficient fastening has been
performed when the switch
trigger has released before
reaching the preset fastening
torque.
This indicates the appropriate
time to replace the battery
cartridge when the battery
power becomes low.
This function works when
the battery power is almost
used up. At this time, tool
stops immediately.
This function works to check the
proper operation of the lamp,
light and beeper when a battery
cartridge has been inserted into
the tool.
This function works when an
abnormal drop of the battery
voltage occurs for some reason,
and the tool stops.
This function works when the
temperature of the controller
goes up very highly, and the
tool stops.
The tool stops when there are
some problems with the clutch.
This function works to avoid the
tool's immediate start upon
insertion of battery cartridge into
the tool with the switch trigger
being pulled.
Status of the lamp/beeper
Lamp
Lights up in
green for
approximately
one second.
Lights up in red. A long beep
Flickers in red A series of long
slowly. beeps
Lights up in red. A long beep
Lights up first in
green, next red. A series of short
(And then the beeps
light comes on.)
Flickers in red
A series of long
and green
beeps
alternatively.
Flickers in red A series of short
quickly. beeps
Flickers in red
A series of long
and green
beeps
alternatively.
Flickers in red
A series of long
and green
beeps
alternatively.
7
Action to be taken
Beeper
-
Retighten the screw
Replace the battery
with fully charged one
Replace the battery
with fully charged one
Replace the battery
with fully charged one
Remove the battery
cartridge immediately
and cool the tool
down.
Ask Makita Authorized
or Factory Service
Center for repairs or
adjustment.
Release the switch
trigger.
-
-